ESU 51820
SwitchPilot V2.0,
4-fach Magnetartikeldekoder, 2 x Servo, DCC/MM, 1A
The
SwitchPilot Servo can be used with DCC or Motorola® protocols. It is compatible
with the DCC norm and reacts to switch commands. It is possible to operate
turnouts from 01 to 508 under Motorola® use. Recognition of control mode is
fully automatic.
Functions
The
SwitchPilot Servo is being powered either directly by the digital central
station itself or separately by a DC- or AC source (transformer). RC servos or
ESU servo motors can be directly connected to its four servo outputs. The 5V
voltage needed as well as the special control impulse is generated by the
SwitchPilot Servo itself. For each servo, not only lever speed can be adjusted
individually but also its end positions. Thus it is possible to operate
especially prototypically slow and powerful turnout motors, independent of
track- and gauge systems. You could also employ the SwitchPilot Servo for
driving signal arms or railway crossings. Also the automatic opening of engine
shed doors does not need to remain a dream.
Programming
The SwitchPilot Servo can be
programmed especially comfortably: For one it supports all DCC modes of
programming including POM (programming in the main). Assuming a command station
with an outlet for a programming track, all adjustments can be controlled and
modified. As RailCom® is integrated, it is also possible to read out and control
recent settings, even during operation. Alternatively you can use the
comfortable three-button input: You are able to control addresses, the end
positions of all four servos and the corresponding motion speed directly, during
operation and without any complicated programming- at all command stations!
Analog operation
The Switch Pilot Servo would
not be a typical ESU product, if it had not even more to offer: You can operate
the decoder without the use of a command station! Conventional switches can be
controlled with the help of eight switch inputs. Therefore fans of “classic”
analog model railway can benefit from the advantages of the servo motor. In
other words: the SwitchPilot Servo does not need a command station to switch and
set servo paths as well as speed.
SwitchPilot Extension
Do you need some relay
outputs in addition to the servo outputs, since you intend to polarize the frog,
for instance, or switch off the track voltage within the signal line section?
Then you should extend your SwitchPilot Servo with the SwitchPilot Extension
relay module: one of its four twin-relay contacts switches simultaneously to the
servo and can be used for potential-free load swichting – ideal for tricky
circuitry!
Protection
As it has been the case with our
loco decoders, in the design phase´s greatest emphasis has been placed upon near
indestructibility of the SwitchPilot Servo decoders. That means ESU quality is
also built into our stationary decoders, now and in the future! You can rely on
it!
Future proof
The internal software of the
SwitchPilot Servo V2.0 can be replaced by a more up-to-date version at any time.
This is done with the aid of the ESU LokProgrammer. That way everything remains
current in case of changes in the standards and you may also profit from new
functions.
Technical
Data
NEW & BOXED
Product safety information
Manufacturer information:
Digimoba Elektronic
Sudetenstraße 10
Bayern
Untersiemau, Deutschland, 96253
info@digimoba.de
https://www.digimoba.de
Produktsicherheit:
Modellbauartikel, kein Spielzeug! Empfohlen für Modellbauer ab 14 Jahren.
There are no reviews yet.